ENGINE 115 4. Loosen and remove the LH Radiator top mount- ing screw (1), along with the washer (2) and grommet (3). Similarly remove the RH mounting screw. 5. Disconnect the electrical connector of radiator fan which is located at bottom side of radiator. 6. Tilt the radiator inwards and lift the radiator along with shroud assembly from the grommet (1) on the bottom mounts, both LH and RH simultane- ously. FITMENT For fitment follow the reverse order of removal. Tighten the following fasteners to the recommended torque. Refer engine tightening torque section. • Radiator top mounting M10 bolt– (4.6 Kg-m) • Refrigerant lines on condenser M6 bolt– (0.81 ~ 1.2 Kg-m) C. RADIATOR FAN SHROUD REMOVAL 1. Remove the recovery bottle . (refer “recovery bot tle removal” procedure.) 2. Disconnect the electrical connections to the radia tor fan. 3. Remove bolts and disconnect filler shroud (1) and (2) from filler neck end. 4. Loosen and remove two mounting bolts of shroud assembly form both right and left side. 5. Separate the shroud assembly from radiator and pull out the shroud from the top. FITMENT For fitment slide the shroud into the mounts till it snaps at the top mounts
RkJQdWJsaXNoZXIy MTIwNTUz