ENGINE 39 FITMENT 1. For fitment, first place the belt, and then tighten the tensioner screw (3) by rotating it in the anticlockwise direction (Loosening direction of a RH threaded screw). 2. Tighten the tensioner bolt (2) to a torque of 4 Kgm and fit the cap. 3. Adjust the belt tension. ALTERNATOR and AC BELT ADJUSTMENT 1. Remove the tensioner cap (1) and loosen the tensioner bolt (2). 2. Adjust the belt tension to as follows: a. To reduce the tension rotate the tensioner screw (3) in clockwise direction (Tightening direction of a RH threaded screw) b. To increase the tension rotate the screw (3) in anti clockwise direction (Loosening direction of a RH threaded screw). Keep belt tension in given range .which is as follows. For new Belt Tension for new belt = 268 ± 10 Hz NOTE This value to be measured in the span between alternator and AC compressor pully (marked as “A” in the above image) Then run the engine for 15 mins. Now the belt has to be retensioned to 244 ± 10 Hz. For reusing same belt In case of reusing the same belt, it should be tensioned to 244 ± 10 Hz. E. INJECTOR REMOVAL 1. Relieve the fuel pressure. (For procedure refer maintenance section in fuel system.) 2. Remove panel (Wiper plenum) (Refer body group) for injector removal. 3. Remove the engine cover (1) by pulling it upwards firmly. 4. Disconnect the injector electrical connecters
RkJQdWJsaXNoZXIy MTIwNTUz