GEAR BOX 6450 44 49. Measure the axial play (Float value) of the counter shaft sub assembly and should be 0.2 mm to 0.5 mm. 50. Place the gasket over the housing parting surface. Align the dowel pins and place the gearbox housing – Rear half over the intermediate plate and tap gently with mallet. 51. Tighten the nuts to the tightening torque of 5kg-m. 52. Tighten the detent plugs with springs and spherical detents to the tightening torque of 2.5kg-m. 53. Control dimension is to be measure as per shim selection procedure as given below: A. Remove the front gear case cover. NOTE: Two-shim selection procedure are as follows: B. The first shim selection for highlighted parts as shown below.
RkJQdWJsaXNoZXIy MTIwNTUz