ENGINE 89 14. Remove CC (Close couple catalytic converter) assembly.(For procedure refer CCC removal in exhaust system section) 15. Relieve the fuel pressure. (For procedure refer maintenance section in fuel system.) 16. Disconnect the fuel line between fuel filter to HP pump and return line from HP pump. 17. Drain the Power steering Oil at the Power steering pump and pipe connecter to Steering RAP. Refer Steering section. 18. Remove the starter motor. Refer Electrical section. 19. Support the Gearbox from below. 20. Hook the engine at the lifting hooks provided. 21. Raise the crane till the chains are in tension. 22.Loosen and remove the Clutch house mounting bolts, (For procedure, refer Gearbox removal in Gearbox section.) 23.Loosen and remove the RH engine mount by approaching from top (Access provided after removing Air filter). 24. Loosen and remove the LH engine mount by reaching out beyond the suspension tower on the inner side of the frame, when approached from the LH wheel arch (Access provided by removal of LH front wheel and Wheel arch inner liner). 25. Slowly lift the Engine out of the engine compartment. CAUTION While lifting the engine out from the engine bay take extra care to avoid the suspended engine hitting the windshield bottom.. Fitment : For fitment follow the reverse order of removal. Tighten the following fasteners to the recommended torque. i) Refrigerant lines on compressor. ii) Engine mounts iii) Exhaust pipe joints & CC Assembly iv) Clutch house mounting bolts. v) Starter motor.
RkJQdWJsaXNoZXIy MTIwNTUz