BODY 63 R. ROOF LINER ASSEMBLY: REMOVAL: 1. Disconnect the roof wiring harness electrical connection. (For procedure refer electrical section). 2. Remove the sunvisor from both ends. (For procedure refer sunvisor removal process.) 3. Remove all grab handles. (For procedure refer grab handle removal process.) 4. Remove the goggle case from the driver side. (For procedure refer goggle case removal process.) 5. Remove the front, central and the rear roof console. (For procedure refer roof console removal process.) 6. Push headliner at rear end edge (near tailgate aperature). Ensure three hook type mounting plastic bracket gets disengaged from metallic bracket present on BIW. 7. Carefully pullout the headliner assembly and remove the same from the vehicle. FITMENT: 1. Properly root the electrical connections of roof lamps. (For details refer electrical section.) 2. Locate the roof and snap all the clips properly. NOTE: a. Before assembly check the condition of the clips if found damaged do not reuse the same replace them with new one. b. Check the condition of foams if deteriorate change the same. 3. Fit all grab handles (5 Nos), the goggle case and sunvisor. (For procedure refer the respective component procedure.) 4. Push headliner and ensure all plastic brackets present on headliner gets engaged with BIW bracket and then override tailgate primary seal lip over headliner trim edge. 5. Fit the roof console assemblies. (For procedure refer roof console assembly procedures.)
RkJQdWJsaXNoZXIy MTIwNTUz