BODY 60 8. Fuel filler assembly is snap fitted at four places. Pry out fuel filler assembly from location shown in below image and partially pull out the fuel filler assembly from the side of push-push knob. 9. Disconnect fuel lid release cable from body panel bracket shown by arrow in below image. 10.Disengage the cable sphere and fuel lid release cable from actuator locking arm. 11.Push locking arm to lock position so that it will not touch to BIW while removing. 12.Disconnect electrical connector of fuel filler assembly. 13.Take out fuel filler assembly from vehicle. FITMENT For fitment follow reverse procedure of removal. Q. GLASS WINDSHIELD GLASS REMOVAL 1. Remove the leaf screen mould and then remove the leaf screen assembly. (For procedure refer leaf screen removal process in this section.) 2. Remove the panel assembly (bracket for wiper mounting). (For procedure refer panel assembly removal process in this section.) 3. Remove the windshield finisher from both side. 4. Remove the “A” pillar trim from both ends. 5. Make a small hole in the sealant from the inside of the cabin near “A” pillar. 6. Pass a steel file through this hole and wrap each end around wood. CAUTION Use appropriate protection to the components to avoid any accidental damage. Do not damage the windshield glass dashboard and sheet metal parts. WARNING Put on gloves to protect your hands. Wear eye protection while cutting the glass sealant with steel wire. 7. With a helper on the outside, pull the steel wire back and forth in sawing motion. Hold the steel wire as close to the windshield as possible to prevent damage to the sheet metal components. 8. Carefully cut the sealant around the entire windshield. FITMENT NOTE: Before fixing the windshield glass following preparations need to be done on the glass and body shell flange area.
RkJQdWJsaXNoZXIy MTIwNTUz