ELECTRICAL 106 4. Snap fit the assembly lower nacelle and assembly upper nacelle, and fit the three mounting screws in the assembly nacelle lower. 5. Snap fit the lower steering column cover. 6. Fit the steering wheel properly. (For procedure refer steering section) COMBI SWITCH STALK REPLACEMENT: CHILD PARTS: REMOVAL: 1. Pull out the lower steering column cover. 2. Remove the both assembly nacelle upper and lower. 3. Disconnect the wiring harness connector from the combi-switch stalk. 4. Remove two mounting screws of light stalk as shown in below given figure. 5. Take out the defective stalk. REFITMENT: 1. Align the new stalk in the combi-switch housing. 2. Fit the two mounting screws. Tightening torque for screws – 0.06 Kgfm. 3. Connect the electrical connection to the switch. 4. Snap fit the assembly lower nacelle and assembly upper nacelle, and tighten the three mounting screws in the assembly nacelle lower. 5. Snap fit the lower steering column cover. CLOCK SPRING: REMOVAL: 1. Remove the steering wheel (For procedures refer steering section). 2. Pull out the steering column lower cover. 3. Loosen three fixing screws of assy necelle lower and assy necelle upper, located in bottom side of assy nacelle lower. 4. Dismantle both necelle from snap fitting and take out the both assy nacelle. 5. Remove four mounting screws of clock spring and take out the clock spring. REFITMENT: For refitment follow the reverse procedure of removal.
RkJQdWJsaXNoZXIy MTIwNTUz