ELECTRICAL 98 8.8.12 FLOAT LEVEL SENSOR Float level sensor gives the information about the water level in washer bottle to the instrument cluster. NOTE: Float Level Sensor: If water level sensed low then, the low water level information will be displayed only one time per Ignition ON. REMOVAL: 1. Remove the front bumper assembly. (For procedure refer body section) 2. Disconnect the electrical connections of float sensor and pull out the float sensor from its mounting hole on the washer bottle (Rubber grommet will be remained in the washer bottle). INSPECTION: (Without removing the float level sensor) Connect the Multimeter at two pin connector. Fill the water in the washer bottle. There should be continuity between the two pins when water level in the washer bottle is more than 1.0 liter. Drain the water and again check the continuity between the two pins. There is no continuity between the pins when the washer bottle is empty. If there is continuity in the pins in washer bottle empty condition then remove the float level sensor and check the orientation of sensor on the washer bottle. If orientation is not ok then fit the float level sensor in proper orientation and again do the continuity checking. REFITMENT: 1. Locate the float sensor in the grommet and press fit the float sensor. NOTE: While fitting float level sensor make sure that the cut portion on the float sensor should be at downward position as shown in the below figure. 2. Connect the electrical connections to float level sensor. 3. Fit the front bumper assembly. (For procedure refer body section)
RkJQdWJsaXNoZXIy MTIwNTUz