C635 TRANSAXLE 35 29.Install the sealing ring to the transmission. 30.Install the Concentric Slave Cylinder (CSC) and bolt to the transmission. Tighten the bolts to 10 Nm (89 in. lbs.) and engage the retention tabs. 31.Connect the hydraulic fitting (2) to the plastic retainer (1). 32.Connect the hydraulic connection at the case. 33.Install the axle seals Transmission and Transfer Case/Manual/SEAL, Axle Drive Shaft/ Removal and Installation). CLEANING Clean the gears. bearings. shafts, synchronizers, thrust washers, oil feeder. shift mechanism, gear case, and bell housing. Do not use solvent to clean sealed bearings. Dry all parts except the bearings with compressed air. Allow the bearings to either air dry or wipe them dry with clean shop towels.
RkJQdWJsaXNoZXIy MTIwNTUz