C635 TRANSAXLE 34 lubricants to come in contact with the sealant for at least one hour after the case halves have been assembled. 22. Apply a uniform bead of LOCTITE®509™ Sealer or equivalent to the sealing surface of the case. 23.Install the gear side case half to the bell housing case half. 24.Install the long case bolts (1) and the short case bolts (2) and tighten to 25 Nm (18 ft. lbs.) using a cross sequence. 25.Patch and install the reverse gear idler retaining bolt using the following process. Tighten to 10 Nm (89 in. lbs.). Remove the remaining traces of the original locking patch with a wire brush or the equivalent. Clean the threads with denatured alcohol and allow to dry. Apply the locking patch using Mopar thread locker. 26. Apply a uniform bead of LOCTITE®509™ Sealer or equivalent to the sealing surface of the case. 27.Install the gear selector assembly; tighten the bolts to 20 Nm (15 ft. lbs.). 28.Apply a uniform bead of Mopar® Threebond RTV Sealer or equivalent to the sealing surface of the NEW input shaft sealing ring.
RkJQdWJsaXNoZXIy MTIwNTUz