KRYOTEC ENGINE 109 2. Bring the first cylinder to TDC and further rotate the crankshaft counterclockwise the equivalent of two teeth on the crankshaft sprocket to lower the piston thus avoiding any interference with the valves during the installation of the cylinder head. NOTE The engine block to cylinder head centering bushings are shorter (12.5 mm) compared to the cylinder head to cylinder head cover centering bushings, so be careful not to reverse them as engine damage may occur. 3. In the order shown, tighten the cylinder head bolts to the proper (Torque Specifications). NOTE Do not to reverse them as it may impair the efficiency of the engine. Use new bolts while installing. The value of 65 N·m (48 ft. lbs.) must be done with a combination of 20 N·m (15 ft. lbs.) and subsequently an increase of 45 N·m (33 ft. lbs.). 4. Place cylinder head cover gasket. NOTE Use new gasket while installing. 5. Install both camshaft in head cover. NOTE Camshaft are not interchangeable. 6. Align and lock the camshaft using cam shaft locking pin. 7. Install exhaust camshaft oil seal and intake camshaft end cover. (Drift -: 2704 5890 3316). NOTE Use new seals while installing.
RkJQdWJsaXNoZXIy MTIwNTUz