BRAKE SYSTEM 551 BRAKES 4. Disengage parking brake cable from rear brake shoe assembly. (Refer rear brake shoe removal) and remove parking brake cable from rear brake shoe assembly. 5. Remove two clamps securing parking brake cable to engine mounting cradle (a) and two clamps securing parking brake cable to the body (b) (Located below floor carpet in the passenger compartment as shown in figure) and remove cable from the body. a b a Installation 1. Do the routing of parking brake cable as shown below. (View from underbody) Rubber grommets Rubber grommets Parking brake cable Parking brake cable Parking brake lever 2. Procedure for rubber grommet fitment is as follows : (a) Apply a small quantity of grease or soap oil on the front end of the grommet. (b) Slightly insert the top portion of the grommet front end into shell. (c) Then push the bottom side of the grommet. (d) Rotate the grommet slightly and ensure that it is not coming out by pulling. 3. Engage the parking brake cable with rear brake shoe assembly and refit brake shoes. (Refer rear brake shoe installation procedure) 4. Refit brake drum. (Refer rear brake drum installation procedure) 5. Snap fit parking brake cable clip attached to the brake back plate as shown below. Insertion of clip is confirmed by “tick” sound. 6. Engage parking brake cablewith parking brake lever by tightening parking brake adjusting nut. (Do not adjust [parking brake cable at this point] 7. Fix parking brake cable in to slots of seat mounting bracket. 8. Fit all mounting clamps of parking brake cable. 9. Adjust parking brake cable. (Refer parking brake cable adjustment procedure)
RkJQdWJsaXNoZXIy MTIwNTUz