458 SUSPENSION SYSTEM NOTE: (a) Ensure that the coil spring end is seating securely on the spring seat at the correct place. If not, noise will be heard. Installation: 1. Install coil spring using coil spring compressor . (b) Ensure that closer pi tched coi l to be assembled at bottom side. 2. Mount wheel(s) and tighten wheel bolts to specified torque. TIGHTENING TORQUE FOR WHEEL BOLTS = 8 - 8.3 Kg-m BUMP STOPPER AND SPRING UPPER SEAT NOTE : Refer Exploded view of Rear Suspension Components while removal and installation process Removal 1. Remove wheel(s) (Refer wheel removal procedure/ Wheels and Tires group 2. Remove coil spring (03) (Refer coil spring removal procedure) 3. Remove spring upper seat (04) 4. Remove bump stopper (02) Inspection: 1. Inspect both components for crack, deformation or damage. Replace if found defective. Installation: 1. Install bump stopper (02) to the cradle/body. NOTE: Before installing, apply soap water on it. 2. Install spring upper seat (04) 3. Install coil spring (03) (Refer coil spring installation procedure) 4. Mount wheel(s) and tighten wheel bolts to specified torque. TIGHTENING TORQUE FOR WHEEL BOLTS = 8 - 8.3 Kg-m
RkJQdWJsaXNoZXIy MTIwNTUz