ENGINE 273 MPFI 157 ENGINE SYSTEM MAINTENANCE Replacement of Accelerator Cable • Remove rear seat completely from vehicle. (Refer Removal procedure of Rear Seat fromBody group) • Take out engine access cover with the help of screw driver. NOTE Six notch locks are provided on insulation engine cover. Insert the screw driver at any notch position to facilitate easy removal of cover from body. • Loosen the nut at the throttle body • Remove the cable from the bracket. • Remove cable terminal from the throttle body. NOTE Make sure not to damage the rubber dust cap. • Cut cable tie from engine cradle. • Remove all clamps for accelerator cable. • Remove clamp from cross member front • Release the cable terminal (pedal side) from accelerator pedal slot. • Press the floor end fitting & push it back out of firewall to take the cable out. • Pull the cable out from underbody from the area near wheel arch.
RkJQdWJsaXNoZXIy MTIwNTUz