ELECTRICAL 31 Sr No DTC No Code Description Probable causes Rectification/Repair actions 30 C1319 - 01 Steering Torque Sensor current Failure - General Electrical Failure 1) Short circuit at torque sensor supply wire. 1) Check connector damaged / cable damaged for torque sensor to ECU on steering column, if cable / connectors are not OK than replace the steering column. 2) Check ECU side connector pin bend /damage than if pins are not ok than replace the ECU. 3) Reset the ECU. Remove the power supply plug connector from ECU and reconnect after about 5 minutes. if DTC are still persist than replace steering column. 31 P062F - 00 Internal Control Module EEPROM Error - No Sub Type Information 1) Internal ECU failure in EEPROM. 1) Reset the ECU. Remove the power supply plug connector from ECU and reconnect after about 5 minutes. 2) If new software available then carry out the software update (Reflash the ECU). If DTC are still persist than replace the ECU. 32 C131A - 04 Control Module Reduced Functionality - System Internal Failure 1) Internal ECU failure. 1) Reset the ECU. Remove the power supply plug connector from ECU and reconnect after about 5 minutes. If DTC are still persist than replace the ECU. 33 C131B - 01 Drive motor control circuit failure - General Electrical Failure 1) Internal ECU failure. 1) Reset the ECU. Remove the power supply plug connector from ECU and reconnect after about 5 minutes. If DTC are still persist than replace the ECU. 34 C131C - 54 Motor calibration comparison Missing - Missing Calibration Steering column and ECU are not paired 1) steering column and ECU should be paired again as per serviceability process( Rotor Position sensor calibration routine) 35 C131D - 01 Rotor Position sensor stimulus - General Electrical Failure Short circuit between rotor position sensor signal lines 1) Check wiring Connections & connectors of power supply if damaged than Replace the vehicle wiring harness or connector. 2) Remove the power supply connector and check the voltage (+12 V at connector which is directly from the battery). If connector Voltage < 9V, check the battery. If error still persists replace the ECU
RkJQdWJsaXNoZXIy MTIwNTUz