TRANSAXLE 140 12. CLUTCH POSITION SENSOR REMOVAL AND RE-FITMENT ON BENCH:- Removal: 1. Remove the ‘Oil Tank’ first (refer the procedure 9. Oil Tank Removal and ReFitment on Bench). 2. Disconnect the connector of the wiring harness from the ‘Clutch Position Sensor’. 3. Unscrew and remove the two screws fixing the ‘Clutch Position Sensor’ on the ‘Power Unit Base Plate’ body. Installation: 1. Position the new ‘Clutch Position Sensor’ on its seat using the two new screws of fixing for reference. 2. Screw the two new screws at the right torque 3.1 ± 0.5 Nm. 3. Connect the connector of the wiring harness on the ‘Clutch Position Sensor’. 13. HYDRAULIC OIL ACCUMLATOR REMOVAL AND RE-FITMENT ON BENCH:- DANGER!! Do not remove hydraulic oil accumulator, it is pressurized unit it can pose a safety threat.
RkJQdWJsaXNoZXIy MTIwNTUz