Automated Manual Transmission 51 carry out the following operations: Bleed air of hydraulic system for gearbox with hydraulic selection Clutch self-calibration enablement. Grid self tuning - service. New actuators (only if the hydraulic actuation unit is being replaced). Remove the car from the lift. Hydraulic Selection Gearbox Speed Selection Position Sensor Removal 1. Place the car on a lift. 2. Position the gear lever at N. 3. Connect the diagnosis equipment and carry out the accumulator depressurization procedure. 4. Remove protection/guard under engine. 5. Remove battery. 6. Remove battery support/drip tray. 7. Remove wiring for manual gearbox hydraulic selection system on hydraulic selection unit 8. Remove hydraulic speed selection hydraulic actuator unit and clutch. 9. Loosen and remove the screws and remove the electro-hydraulic selection gearbox gear selection position sensor. 10. Remove the driver complete with O-ring. Hydraulic Selection Gearbox Speed Selection Position Sensor Fitment 1. Place the driver (1a) back in its housing, complete with O-ring, taking care to attach the pin (1b) with the fork (1c). 2. Place the electro-hydraulic selection gearbox gear selection position sensor (1a) back in its housing, inserting the driver pin (1b) in the Sensor (1c).
RkJQdWJsaXNoZXIy MTIwNTUz