Automated Manual Transmission 35 Hydraulic Clutch Actuator with Coaxial Control with Gearbox Removed Removal: NOTE: Back to hydraulic selection gearbox clutch position sensor. 1. Prise up the protection from the gearbox bell housing and remove it. 1. Open the retaining tabs (1a), Loosen the screws (1b) and remove the coaxial control hydraulic clutch actuator (1c). Hydraulic Clutch Actuator with Coaxial Control with Gearbox Removed Fitment: 1. Apply sealant to the new flange and oil seal and place it in position. 1. Place the coaxial control hydraulic clutch actuator (1a) back in its housing and tighten the screws (1b) to the prescribed torque. Component Fixing Diameter Value (Nm) Clutch Control coaxial actuator Screw M6 9 – 11 2. Fold over the retaining tabs for the flange with oil seal. Place the gearbox bell housing protection back in position.
RkJQdWJsaXNoZXIy MTIwNTUz