Automated Manual Transmission 34 1. Remove the O-ring from the electric pump. 1. Remove the ring for the connector on the reservoir. Electro Hydraulic Circuit Reservoir And System Pump Fitment: Place the hydraulic circuit fluid reservoir in its housing complete with ring for the connector and tighten the corresponding screws. Place the hydraulic circuit pressure sensor in its housing and screw it in. Place the wiring retaining clip in its housing and tighten the corresponding screw. Place the hydraulic circuit fluid reservoir mounting in its housing. Connect the electrical connection for the gearbox input speed sensor. Connect the electrical connection for the electric pump. Tighten the hydraulic circuit fluid reservoir mounting upper fixing screw. - Connect the electrical connection for the hydraulic circuit pressure sensor. Tighten the connector for the pipe from electric pump to hydraulic unit, electric pump side. Place the protection /guard under the engine. Place pressure accumulator on hydraulic actuator unit. Place the heat protection bulkhead on gearbox hydraulic circuit fluid reservoir with electro hydraulic selection. Refill the electro-hydraulic selection gearbox hydraulic control system, with reference to Hydraulic system fluid for gearbox with hydraulic selection checks level and top up, if necessary Place the battery, battery tray and connect the battery. Connect the diagnosis equipment and carry out the following operations: Hydraulic system for gearbox with hydraulic selection - bleed air Clutch self-calibration enablement. Grid self tuning - service. New actuators (only if the hydraulic actuation unit is being replaced). Remove the Car from the lift.
RkJQdWJsaXNoZXIy MTIwNTUz