DRIVETRAIN C549 42 4 1.2.6. INPUT SHAFT SEAL REPLACE- MENT 1. Remove the clutch hydraulic actuator. 2. Unscrew the bolts (1a) and remove the TRANSAXLE input shaft cover with built in gasket (1b). 3. Replace the TRANSAXLE input shaft cover with built in gasket in position and secure it using the bolts. 4. Place the clutch hydraulic actuator in position 4A.1.3.DRIVE SHAFT 4A.1.3.1 INTRODUCTION (a) 1.3 QUADRAJET Driveshaft installed on Bolt/Zest (QUADRAJET) is as shown in the figure below an intermediate driveshaft transmits drive to the right driveshaft. This solution allows drive torque to be is distributed in perfectly symmetrical manner over both wheels. In this way the curving of the longer driveshaft, through bending, due to the drive torque transmitted, which could cause vibrations to the dynamic geometry of the vehicle, is avoided.
RkJQdWJsaXNoZXIy MTIwNTUz