SUSPENSION 30 18. Remove circlip from knuckle. 19. Pull out knuckle bearing using puller part No. 2779 5890 3302 INSTALLATION: 1. Follow the above steps in reverse order in appropriate sequence for its assembly. NOTE: High / Low point matching on Hub and Disc Observe the condition of disc surface. If the disc surface is smooth ensure that punch mark (Low Point) on disc and hub (High Point) are aligned and assembled. If the disc surface is uneven showing rough marks, grooves - machine it to the specified limit; measure the run out on dia 220 w.r.t. hub and disc resting face. Punch mark around bolt hole where run out on dia 220 is at low point. Align low point on disc and high point on hub while assembly. Assemble with countersunk screws. 2. Tighten drive shaft nut 17.5 ± 2 kg-m torque and lock by staking. 3. Ensure that oil seal in transaxle is not damaged while fitting drive shaft. PRECAUTION: Use a new hub bearing and new circlip, oil the bearing housing in knuckle carrier and hub itself. Old bearing, even if serviceable cannot be reused. SUB ASSEMBLY - KNUCKLE / HUB: Clean all the parts thoroughly and replace damage / worn out parts. 1. With the help of drift part No. 2779 5890 3301 and 2640 5890 3511 fit bearing in the knuckle 2. Fit circlip.
RkJQdWJsaXNoZXIy MTIwNTUz