BODY 20 18.Remove A pillar Upper trim on both sides. (For procedure refer A pillar removal process). 19.Disconnect the tweeter electrical connection at both sides and antenna connection at the LH side and roof lamp connection at the RH side. (RH side illustrated). 20.Disengage the assembly from 3 locators located on BIW plenum panel brackets. 21.Remove the dashboard along with other aggregate as shown, while removing Dashboard carefully disengage HVAC system electrical connection. ON BENCH COCKPIT DISMANTLING 22.Remove steering wheel with Driver air bag (If applicable) (For procedure follow the steps as mentioned in dash board skin removal). 23.Pull out Driver lower panel. (For procedure follow the steps as mentioned in dash board skin removal). 24.Remove nacelle Assembly. (For procedure follow the steps as mentioned in dash board skin removal). 25.Remove the steering column. (For procedure follow the steps as mentioned in Steering section). 26.Remove combination switch assembly and ignition switch assembly (For procedure follow the steps as mentioned in dash board skin removal). 27.Remove instrument cluster. (For procedure follow the steps as mentioned in dash board skin removal). 28.Pry out gap hider fitted on the dashboard sub assembly. (For procedure follow the steps as mentioned in dash board skin removal). 29.Pry out center facia and air vent assembly along with Hazard switch and Fascia switch. (For procedure follow the steps as mentioned in dash board skin removal). 30.Remove music system (If applicable(For procedure follow the steps as mentioned in dash board skin removal). 31.Remove the glove box. (For procedure follow the steps as mentioned in dash board skin removal).
RkJQdWJsaXNoZXIy MTIwNTUz