SUSPENSION 2 Note: 1. It is recommended to set toe & camber values at mid of the specification range. 2. It is recommended to have minimum difference between LH & RH set camber values. The difference between LH & RH set values should be not be within 20’ maximum. 1.2. TIGHTENING TORQUES SR. NO. DESCRIPTION TORQUE VALUE (Kg-m) FRONT SUSPENSION 1 Front Strut mounting on BIW 2.3 2 Front Strut top mounting 6-7 3 Front strut mounting on Knuckle 8 4 ABS sensor mounting on knuckle 0.8-1.0 5 Driveshaft lock nut 23-26 6 Lower ball joint mounting on knuckle 5.5 7 Lower control arm to BIW mounting (Front & rear pivot) 10* Lower control arm front mounting pin & Tie member clamping nut 12* Vertical member top & bottom assembly (Partial sub frame) 2.3 8 Antiroll bar mounting on BIW 4.5* 9 Stab link mounting on strut 5.5 10 Stab link on anti-roll bar 5.5 REAR SUSPENSION 1 Rear Strut mounting on BIW 4.5 2 Rear Strut top mounting 6-7 3 Rear Strut stopper assy. 2 4 Rear Strut bottom mounting 13 5 Torsion beam bracket mounting on body 10 6 Twist beam pivot bush cross bolt 10* 7 Anchor plate and spindle mounting bolts 4.5 8 Brake drum mounting lock nut 17.5 ± 2
RkJQdWJsaXNoZXIy MTIwNTUz