ALTROZ SERVICE MANUAL

SUSPENSION 39 9.13 ON VEHICLE TORSION BEAM REMOVAL AND ASSEMBLY REMOVAL 1. Position the vehicle in the two post lift. 2. Remove the wheel cap and loosen wheel nuts. 3. Lift the vehicle using two post lift. 4. Remove the wheel. 5. Remove the brake drum by gently tapping by mallet. 6. Slacken off the hand brake cable. 7. Detach the hand brake cable from the lever on the trailing shoe by moving the lever towards the center of the brake and removing the cable nipple from its location in the end of the lever. 8. Remove the hand brake cable holder lock pin from the back plate. 9. Insert a screwdriver through the hole in drum and press against the hand brake lever. 10.A ‘click’ will be heard as the lever moves down. This movement compresses the pistons in the wheel cylinder and thereby increases the clearance between the brake shoes and the drum. 11.Remove the rear sensor cable mountings on the twist beam axle. 12.Disconnect the brake lines mounting on the twist beam. 13.Disconnect the bundy pipe/Hose from wheel cylinder. Remove bleed screw. Put rubber dust cap on to the bundy pipe to avoid brake fluid from spilling and contamination.