NEXON BSVI MCE - SERVICE MANUAL

TRANSAXLE TA6300 AMT 34 15. Remove stub axle ball joint Mounting & Loosen Lower Control Arm on LH & RH side. 16. Remove ball joint (steering rack) from steering knuckle from both sides. 17. Remove vertical link mountings on suspension rod for both RH & LH sides. 18. Remove pre silencer Assy with pipe, front & outlet pipe. 19. Remove 2 mtg bolt of intermediate shaft heat shield & take out heat shield. 20. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side. 21. Remove Drive shaft from co-driver side. NOTE: C are should be taken not to damage driveshaft oil seal and its boots (do not use hammer) . CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot.