NEXON BSVI MCE - SERVICE MANUAL

DRIVESHAFT MT 11 9. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side/Engine side. 10. Remove Drive shaft from co-driver side. NOTE: C are should be taken not to damage driveshaft oil seal and its boots (do not use hammer). CAUTION: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. FITMENT For fitment follow the reverse procedure of removal. B. DRIVE SHAFT (LH / RH) REMOVAL (DIESEL VEHICLE) 1. Position the vehicle properly on the two-post lift. 2. Lift the vehicle on using two-post lift and remove the front wheels LH & RH. 3. Drain the Transaxle oil through Drain Plug. 4. Remove earthing cable from gear box. 5. Remove stub axle ball joint Mounting & Loosen Lower Control Arm on LH & RH side.