NEXON BSVI MCE - SERVICE MANUAL

TRANSAXLE TA6300 31  Take the bearing puller (5438 5809 2617) and place outer hub of the puller on the machined surface of transaxle casing, surrounding of the countershaft bearing.  Rotate the pulling nut 30 mm anticlockwise and allow anchoring body shaft of puller to get inserted inside the bearing.  Once the anchoring body is inserted fully, hold the locking stud on the top using open end spanner 8 mm and turn the locking nut on the top slowly using open end spanner 17 mm, few turns till it gets resistance to rotate.  It allows flaring the anchoring body and gets lock with bearing rollers. CAUTION: Please stop once the shaft is locked, excess rotation of locking nut may cause damage to puller of bearing.  Once the anchoring body is locked with bearing hold the anchoring body shaft at the top using the open end spanner 18 mm.  Use the open-end spanner 30 mm and turn the pulling nut clockwise, do not allow anchoring shaft to turn along with pulling nut.  It will start to pull the bearing out from the casing.  Turn the pulling nut (30 mm) till the bearing comes out completely from the casing.