NEXON BSVI MCE - SERVICE MANUAL

1.2L REVOTRON ENGINE 129 4. Remove the locking bolt and take out the balancer shaft from the bedplate as indicated. 5. Remove the mounting fasteners holding the connecting rod bearing caps. NOTE  While removing each bearing shell, mark on its back in case of reuse.  Connecting rods have to be assembled to the respective bearing caps, matching with serial numbers 6. Remove the bearing shell from bearing cap. 7. Turn crankshaft to bring piston to top dead center. 8. Remove piston assembly from the cylinder block using wooden handle of the mallet. 9. Follow the same procedure to remove the remaining two pistons. 10. Using suitable pliers, remove piston pin round wire circlip. 11. Remove the connecting rod bearing caps along with bearing shells.