TIAGO TIGOR CNG - SERVICE MANUAL

DRIVESHAFT_CNG 14 9. Align the inner race spline and the axle spline in 1800 position and press the CV joint assembly in to the axle bar until the joint could not move further in the axle bar. Gently tap the CV outer axially with a mallet if required. This ensures that the retaining ring is engaged in the inner race. 10. Slide the boot seal into the seal groove on the axle shaft and check the clamp position to ensure that it is positioned correctly around the entire circumference, then crimp the small retainer by using the crimping pincer tool Maintain the ear gap of 2.5 mm. 11. Place the remaining grease from the service kit inside the seal and slide the larger diameter of the seal with the larger seal retaining clamp in place over the outside of CV joint. Important: The CV seal must not be dimpled, stretched or out of shape in any way. If seal is not shaped correctly equalize pressure. 12. Crimp the seal retaining clamp using pincer tool and maintain ear gap of 2.6 mm.