SAFARI BSVI SERVICE MANUAL

SUPPLEMENTARY RESTRAINT SYSTEM (SRS) 21 ON VEHICLE SERVICE REMOVAL / ASSEMBLY The front seat buckle are bolted on Seat architecture inboard side. The tongue must always be latched in the buckle while driving. The wire harness on buckle must be fixed at 3 positions as shown in the images alongside namely 1 ,2 and 3. The SAB connector must be clipped at positon 4 as shown in image. FITMENT For fitment follow reverse procedure of removal. NOTE After fitment connect the diagnostic tool and clear fault codes, if any. CURTAIN AIRBAG In the vehicle, folded curtain airbag is installed on the cantrail behind roof headliner on side of the vehicle. When collision occurs the curtain airbag is deployed, pushes the headliner out of the way and position itself between occupant and side window of the vehicle to protect the occupant's head from having hard contact with side structure of vehicle or with the intruding external objects. The curtain airbag also enhances protection for the second row outboard occupant. ON VEHICLE REPAIR REMOVAL NOTE Disconnect the vehicle battery and wait for 10 min before commencing work on side airbag. 1. Remove “A, B and C” pillar trims. (For procedure refer Cab section.) 2. Disconnect the electrical connections of roof liner assembly from “A-Pillar” at both ends. 3. Disconnect the rear washer pipe joint from the “A-pillar”. 4. Remove the sunvisor. (For procedure refer sunvisor removal in CAB section.) 5. Remove all the grab handles and goggle case from driver side. (For removal procedures refer CAB section.) 6. Remove front, middle and rear roof consoles. (For procedure refer removal in CAB section.) 7. Loosen and remove the mounting screw which is located below the rear roof console. 8. Remove the roof liner assembly.