SAFARI BSVI SERVICE MANUAL

ELECTRICAL 22 4. No output from BCM (HIGH) Refer BCM Diagnosis Indicator lamps not working when hazard warning switch is operated 1. 8 pole connector at the front fascia panel switch loose Fix the connector terminal properly 2. Hazard warning switch faulty Replace switch 3. No output from BCM Refer BCM diagnosis Reverse lamp not working 1. Grounding point no. E00 loose Tighten grounding properly 2. Bulb fused Replace bulb if blown 3. 8 pole tail lamp connector loose. Fix the connector properly Stop (Brake) lamps not working 1. 8 pole tail lamp connector loose Tighten the connector properly 2. Bulbs fused Fix the bulbs properly. Replace bulbs if blown 3. Brake lamp switch faulty Replace switch Stop Lamps are controlled by BCM. If issue not resolved by above methods, BCM diagnosis should be referred. Stop(Brake) Lamp and High Mounted Stop Lamp not working 1. Stop Lamp and High Mounted Stop lamp 10A. Fuse in Cabin Fuse Box Blown Replace Fuse Single front parking lamp not working 1. Head Lamp connector Fix connector properly(10 pole) loose 2. Grounding point loose Tighten the grounding properly 3. Bulb fused Fix the bulb properly. Replace bulb if blown 4. Parking lamp LH/RH fuse (5A) Cabin fuse box loose/blown the circuit and then replace Fix the fuse properly in the base. i n If blown, check for short in the fuse 5. No output from BCM Refer BCM Diagnosis Single rear parking lamp not working 1. Grounding point loose Tighten grounding properly 2. Parking lamp LH/RH fuse(5A) Cabin fuse box loose /blown Fix the fuse properly in the base, i n if blown, check for short in the circuit and then replace the fuse 3. Bulb fused Replace bulb if blown