SAFARI BSVI SERVICE MANUAL

BRAKES (EPB) 30  Nevertheless, an angle adjustment is allowed in order to make sure that the two piston face grooves are aligned with the caliper reference. This, in order to facilitate caliper reassembly.  when pushing back piston, check that piston boot returns to its housing Without deformation and without overhanging of the piston face. This could result in boot cut by pads at caliper assembly, or boot burning by contact with hot pads during service. INSPECTION Measure the pad lining thickness if it is found to be 1mm or less anywhere, it has to replace. The inboard pads of rear brakes are provide with the wear indicator. 4. Inspect and clean the brake disc. 5. Sliders replacement. 6. New pads assembly. CAUTION: Check that pins at the back of inner pads are placed inside piston face groove. 7. Caliper Closing. 8. Brake Connection to Vehicle. Complete pad change sequence of APB system by calling the ‘Exit maintenance mode’ service via the ESP diagnostic tool . 9. Repeat the above steps for the other side of the axle. NOTE  Apply brake pedal couple of times with the engine started before taking the vehicle for a road test. Before applying an emergency brake, it is advisable to apply the brake gently several times at 50 Km per hour to allow the brake pads align. Heavy braking or prolonged braking should be avoided in the initial 100-150 km. of run until the new pads are bedded. Piston grooves Pad Pin