SAFARI BSVI SERVICE MANUAL

DRIVESHAFT (AT) 13 7. ON VEHICLE PROCEDURE DO’s and DON’T’s 1. Take all precautions to avoid damage to the surface of the thread, splines. 2. Avoid contact between the inboard/outboard seal and tooling used to insert the assembly into the transmission/wheel end side. 3. Avoid contact between the ear of the clamp and any object which may bend/crush the clamp which will result into grease leakage and/or intrusion of water/debris. 4. Do not over extend the inboard/outboard joint. 5. Always lift the half shaft by holding it at axle bar.