NANO

TRANSAXLE 137 10. OIL TANK REMOVAL AND REFITMENT ON BENCH:- CAUTION Ensure there is ‘NO PRESSURE’ in the hydraulic circuit. Removal: 1. Unscrew the ‘Oil Tank Cap’ and empty the hydraulic oil from the ‘Oil Tank’ in a canister. 2. Unscrew and remove the three screws M6x15 fixing ‘Oil Tank’ on ‘Power Unit Base Plate’ body. 3. Unscrew and remove the other screws M6x20 located under the ‘Power Unit Base Plate’ body. With the Hydraulic System upright to avoid oil draining from e ‘Power Unit Base Plate’, remove the ‘Oil Tank’ pulling by hand in vertical direction. 4. Remove the ‘Oil Tank’ O-ring that normally remains inside the ‘Power Unit Base Plate’ seat, and assemble it in the original position on the ‘Oil Tank’, if the tank is reused. Installation: 1. Insert the ‘Oil Tank’ outlet port inside the ‘Power Unit Base Plate’ inlet port by moving it vertically towards the mating surface. 2. When the ‘Oil Tank’ O-ring comes in contact with the ‘Power Unit Base Plate’ seat, push it slowly with appropriate load, applied by operator’s hand, to complete the assembly. 3. Screw the ‘New Screw M6x20’ for fixing ‘Oil Tank’ under ‘Power Unit Base Plate’ body at the right torque 10 ± 1 Nm.