NANO

TRANSAXLE (NANO AMT) 91 7. Place the synchro cone and then place the fourth gear on it. 8. Place the spacer (input Shaft) on the fourth gear. 9. Fit the rear end ball bearing using the tool 2702 5890 35 04 (Drift for rear hub inner bearing outer race), such that the snap ring groove is uncovered. NOTE: Measure the axial float using a dial gauge; float should be within 0.2 ~ 0.4mm. 10. Heat the input shaft bush up to 52- 60deg. Insert the bush on input shaft from front end and ensure proper fitment of bush up to the given collar. 7. LAYSHAFT ASSEMBLY: A. DISMANTLING: 1. Hold the Lay shaft in a bench vice such that the rear half side is on the top. 2. NOTE: To ensure that the gears/ splines do not get damaged by the vice jaws, pad it with wooden pieces or any other softer material. 3. Remove the rear end ball bearing using the puller tool (Tool No. 2834 5890 2604 PULLER FOR REMOVAL OF REAR BRG. FROM INPUT SHAFT & LAYSHAFT).