NANO

TRANSAXLE (NANO AMT) 83 4. REMOVAL OF TRANSAXLE FROM VEHICLE: 1. Drain the transmission oil. For procedure refer ‘Transaxle oil drain’. 2. Disconnect the vehicle speed sensor connector. 3. Disconnect battery, starter motor and AMT kit electrical connections. 4. Remove the starter motor. For procedure refer “Electrical Group”. 5. Disengage the exhaust silencer bracket (Near catalytic convertor joints) from transaxle, by loosening and removing the bolts (02 No’s). 6. Loosen the bolts and remove the exhaust silencer. 7. Remove the drive shaft heat shield mounting. 8. Remove the wiring harness from transmission front half bracket. 9. Remove the LH semi-trailing arm along with shock absorber and coil spring. For procedure refer ‘Semi- Trailing arm, Shock absorber and Coil Spring Removal’ – Suspension Group’. 10. Loosen the three bolts of the back cover and remove the back cover. 11. Remove the LH driveshaf t completely and disconnect the RH driveshaft from the transaxle end. For procedure refer ‘Drive Shaft removal’. 12. Support the engine and transaxle (separately) either using a stand from below or a suspender from above. 13. Loosen and remove the bolts holding the transaxle housing to engine housing from engine side. 14. Loosen and remove the bolts (03 No’s) holding the transaxle housing to engine housing from transaxle side.