NANO

ELECTRICAL 695 ELECTRICAL REMOVAL & REFITMENT OF STEERING LOCK CUM IGNITION SWITCH REMOVAL 1. Remove steering wheel (Refer “Steering section”) 2. Remove the screw securing steering column lower panel to the body. 3. Remove two screws securing steering column upper panel to the lower panel and take out lower panel. 4. Remove two bolts securing ignition switch assembly to the steering column. 5. Disconnect electrical connector and take out the ignition switch assembly. INSPECTION : • Turn the ignition switch to the off position and back-probe, with the meter’s positive lead, the power feed wire at the module. • Connect the meter’s negative to a good ground at the distributor base. • Turn the ignition to the run or start position as needed, and measure the voltage. • The reading should be at least 90% of battery voltage. • The key should be come out at lock position only. REFITMENT : 1. Align steering lock cum ignition switch assembly and tighten two mounting bolts. Connect the electrical connector. 2. Fit steering column lower panel. 3. Fit steering wheel.