NANO

672 ELECTRICAL WIPER CARE 1. Wiper blade attack angle on windshield glass should be 90 °C i. e. perpendicular. Remove wiper and set wiper arm on windshield glass in the centre position, check the gap between arm strip and glass. Adjust by twisting wiper arm strip as shown in the figure. 2. Straighten the secondary lever & yoke, if found twisted. Slide the flexer inside the rubber, if found protruding out and crimp the claw to avoid it from coming out again. 3. Lubricate hinge joint area with oil, once a month to achieve proper arm pressure. 4. Check the wiper blades at least twice a year or when they seem less effective. Substances such as tree sap and some hot wax treatments used by commercial car washes reduce the effectiveness of wiper blades. 5. If the wiper blades do not wipe properly, clean both the windshield and wiper blades using undiluted windshield wiper solution or amild detergent. Rinse thoroughly with clean water. To avoid damaging the blades, do not use fuel, kerosene, paint thinner, or other solvents. 6. When replacing wiper blade assemblies, always use specified parts or equivalents. To make replacing the wipers easy, turn the ignition toACC, and then turn the wipers on. When the wiper reaches the vertical position, turn the ignition to LOCK.