NANO

548 BRAKE SYSTEM INSTALLATION ON VEHICLE 1. Install wheel cylinder onto brake back plate and tighten two mounting bolts to specified torque. TIGHTENING TORQUE FOR WHEEL CYLINDER MOUNTING BOLTS = 0.8 - 1.2 Kg-m 2. Connect brake pipe to wheel cylinder. Tighten the brake pipe nut to specified torque. TIGHTENING TORQUE FOR BRAKE PIPE NUT = 1.4 - 1.6 Kg-m CAUTION: Over tightening of bleed screw leads to breaking of screw which may cause to replace a wheel cylinder assembly. 3. Install rubber dust cap taken off from brake pipe to bleeder plug. 4. Refit brake shoe assembly. (Refer Front/Rear Brake Shoe installation procedure) 5. Top up brake fluid to correct level and do the brake bleeding. (Refer brake bleeding procedure) 6. After completion of all jobs press brake pedal 3 to 5 times so as to obtain proper drum to shoe clearance. 7. Adjust parking brake cable. (Refer parking brake adjustment) 8. Mount wheel(s) and tighten wheel bolts to specified torque. TIGHTENING TORQUE FOR WHEEL BOLTS = 8 - 8.3 Kg-m 9. Remove supports and lower the vehicle.