NANO

464 SUSPENSION SYSTEM Wheel bearing Wheel bearing housing NOTE: Load should be applied concentric to the bearing axis to avoid skewing and improper fitting of bearing in housing. 9. Once the wheel bearing housing along with the wheel bearing is removed from the flange, use special tool (Part number - 2834 5890 35 01) for removing the inner race of wheel bearing from the flange Inspection : 1. Inspect wheel bearing for noisy and smooth operation. Replace if found noisy. 2. Inspect wheel hub unit for any damage. Replace if found defective. Following precautions should be taken while assembly : (a) Hub cavities should be free from dust, rusting and other foreign particles. (b) Handle the bearing with clean and dry hands. (c) Never use hand gloves while assembling bearing. (d) Never hammer the bearing while assembly and disassembly, use suitable press. (e) All greased parts (bearing) must be protected from dust. (f) Complete assembly to be done in burr and dust free environment. (g) Lubricate wheel bearing outer surface with oil so that it gets inserted into wheel bearing housing easily. 7. Remove internal circlip (04) from wheel bearing housing with the help of circlip plier. 8. Remove wheel bearing (03) from wheel bearing housing (02) as follows: (a) Place the wheel bearing housing on hydraulic press. (b) Press the wheel bearing by using special tool (Part No. 2834 5890 32 01) on hydraulic press and remove wheel bearing fromwheel bearing housing. 04