NANO

416 DRIVETRAIN NOTE : Whenever the driveshaft is removed (either LH or RH side) the oil seal (as shown by arrow) must be replaced. Installation of driveshaft on vehicle 1. Align and insert the driveshaft properly into wheel hub housing. 2. Keep the driveshaft in horizontal position such that the splines of the driveshaft (transaxle end) match with transaxle. 3. Align and insert the driveshaft properly into the transaxle. 4. Lift the support up (by lowering the hoist) in such a way that shock absorber lower mounting bolt aligns with semi trailing arm frame. 5. Hand tighten shock absorber lower mounting bolt. 6. Remove the support and tighten shock absorber lower mounting bolt to specified torque. TIGHTENING TORQUE FOR SHOCK ABSORBER BOLTS = 4 Kg-m 7. Tighten the inner mounting bolt of semi trailing arm to specified torque. TIGHTENING TORQUE FOR SEMI TRAILING ARM CRADLE BOLTS = 8 Kg-m 8. Tighten the axle nut to specified torque. TIGHTENING TORQUE FOR AXLE NUT = 17 Kg-m 9. Fit wheel(s) and tighten wheel bolts to specified torque. Remove stands and lower vehicle. TIGHTENING TORQUE FOR WHEEL BOLTS = 8 - 8.3 kg-m 10.Top-up transaxle oil. NOTE : 1. During the whole process of installing the drive shaft on vehicle, the boot and machined surface should never contact any component of the vehicle. 2. All precautions should be taken to avoid damage to threads and splines of the joint.