NANO

DRIVETRAIN 381 DRIVETRAIN SHIFTER SHAFT AND SHIFTER FORK A. DISMANTLING 1 Position the first and second gear shifter shaft assembly in a bench vice and remove the Dowel pin and separate the shifter dog from the assembly. 2 Similarly, dismantle the third and fourth gear shifter shaft assembly and the reverse shifter shaft assembly. 3 Dismantle the reverse gear shifter bracket by unscrewing and removing thePivot (01), and flange nut (02). 4 Remove the Reverse idler shifter finger (03) and remove the detent assembly (04). B. ASSEMBLY 1. Assemble the first and second gear shifter by placing the shifter fork on its flat surface. 2. Insert the first and second gear shifter shaft such that the shaft end closer to the slot goes into the fork first as shown in the fig. 3. Then fit the dowel (spiral) pin such that it does not protrude out from both ends by holding the fork and shaft assembly in a vice and using a suitable drift. 4. Assemble the third and fourth gear shifter by placing the shifter fork in a flat surface. 5. Insert the shaft such that the slot goes into the fork first followed by the groove.