NANO

ENGINE 273 MPFI 203 ENGINE Inspection: • While removing fuel tank, check all hoses and pipes connected to fuel tank for leaks, loose connections, deterioration or damage. Replace if necessary. • Check fuel module gasket for leaks, cracks etc. Replace if necessary. • Visually inspect fuel tank for leaks and damage. Replace if necessary. Fuel Tank Purging Procedure : A small amount of fuel may be released after fuel lines are disconnected. To avoid the chances of injury, cover the pipe to be disconnected with cotton cloth. Do not use cotton waste. To avoid damage to vapour hoses whi le disconnecting, slide back the clamps then twist the lines as you pull. When disconnecting fuel hose quick connectors, use shop towels to absorb fuel, protecting equipment and personnel, safety devices. WARNING CAUTION The purging may not remove all fuel vapours. Therefore any repair on fuel tank using external heat or flame may result in explosion causing personal injury or damage. Wash the tank throughly before carrying any repair • Remove fuel tank from the vehicle. (Refer procedure as mentioned for fuel tank removal.) • Remove fuel module from fuel tank. • Shift the tank to flushing area. • Fill tank with warm water or normal tap water and agitate rigorously and drain the water. • Repeat this procedure until inside of tank is clean. Replace the fuel tank if it is rusty from inside. • Completely flush out remainingwater after washing. WARNING Do not allow water to remain inside fuel tank after washing. This will cause corrosion inside fuel tank. Use shop cotton cloth for tank cleaning. Do not use cotton waste. • Unscrew tank hexagonal mounting bolts and loosen the tank from car under body.