NEXON

SUSPENSION 37 INSTALLATION OF REAR SHOCK ABSORBER AND COIL SPRINGS: 1. Refit the shock absorber top mounting fasteners with new nylon nut in the luggage compartment and tighten to 2.5 to 3 kgm Torque as shown in Figure. 2. Fit and rotate the top rubber with the coil spring. LH Spring Orientation RH Spring Orientation 3. Position the spring bottom rubber pad is to fixed to twist beam in two holes. Spring to be oriented such that end rest and against the stopper of bottom rubber pad as shown in fig 4. Raise the torsion beam using hydraulic jack so that the coil spring gets compressed and shock absorber sits exactly over torsion beam properly. 5. Refit and Torque Rear Shock Absorber Bottom Fastener.( as per torque table). 6. Refit the rear wheels. 7. Remove the Car from 2 Post Lift. NOTE: While fitment of damper the bottom bus to be tighten in ECIE condition. Jacking on the beam not to be done to avoid failure .