NEXON

TRANSAXLE TA6300 30 17. Remove 3 allen bolt of intermediate shaft & take out Drive shaft from driver side/Engine side. 18. Remove Drive shaft from co-driver side. Note: Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. 19. Remove Exhaust Front pipe mounting Bracket on silencer support assembly to make accessibility for Hex Flange bolt on gear box as shown. 20. Remove C-Bracket mountings from Subframe assembly & Gear box also take out C-mounting bracket. 21. Give push support from bottom side of Engine Assembly. 22. Loosen the B- mountings 23. Remove hex flange bolt as shown on gear box housing as shown