NEXON

CLUTCH 19 Ensure flywheel free from oil/grease/damage. Locate SAC assembly on flywheel dowels; align its mounting holes with tapped holes in the flywheel. Ensure SAC is correctly located in three dowel pins. Use 9 Nos. Hex Head Screw M6x18 - 10.9 along with B6 spring washer for SAC mounting. Aligning mandrel in position.Tighten only two rounds of each screw at a time as per sequence shown and repeat the sequence till full tightening. Tighten these screws in the same sequence to 1.3 mkg. Ensure correct torque is applied to all the screws. Ensure that there is no gap between SAC cover & flywheel at 6 mounting locations. NOTE Do not mix clutch mounting bolts with other fasteners. Do not use longer or shorter screws. Longer screws may not tighten the clutch at all. Shorter screws will not provide enough threads to achieve desired tightening. While tightening clutch mounting screws check aligning mandrel for continuous free sliding to ensure concentric installation of clutch disc which will avoid trouble during installation of gearbox. CAUTION 1. Ensure same pair number marking on SAC & Disc while assembly. 2. Replacement of SAC should be as a set only. 3. Do not replace individual clutch disc or SAC.