NEXON

1.5L REVOTORQ ENGINE 56 4. Disconnect the electrical connection to the fuel filter. 5. Push the fuel filter in upward direction and take it out from the groove in mounting bracket. INSTALLATION 1. Place the fuel filter in the mounting bracket. Be sure to orient the fuel filter in the proper direction. 2. Press the fuel filter in downward direction and fit it on the groove in mounting bracket. 3. Connect the fuel lines to the filter, making sure the lines are secure. 4. Lower down the vehicle from hoist 5. Start the engine and inspect the connections for leaks. Stop the engine immediately and repair if any leaks. v. DRAINING WATER FROM FUEL FILTER 1. Stop the engine allow the pressure to stabilize. 2. Disconnect the electrical connection of the drain water sensor and also disconnect one of the fuel lines either inlet or outlet. 3. Keep a suitable container to collect the drained water. 4. Rotate the drain water sensor in anti- clockwise direction for about 2 turns and allow approximately 120cc of diesel to drain and then tighten the sensor. (Tightening Torque: 1.4 ± 0.2 Nm) 5. Reconnect the fuel line and electrical connection that was disconnected. 6. Drain the water from the fuel filter bowl during every service.