NEXON

HVAC 27 STEP INSPECTION ACTION 6 Verify whether malfunction is in expansion valve, receiver/drier and refrigerant lines or elsewhere Are refrigerant’s high-pressure and low-pressure values low? Yes Go to next step No Go to step 14 7 Verify whether malfunction is in expansion valve and receiver /drier or elsewhere immediately after A/C compressor operates, does refrig- erant’s high-pressure value momentarily rise to correct value, then fall and stay below it? (Is there negative pressure on low-pressure side?) Yes Go to next step No Go to step 10. 8 Verify whether malfunction is in expansion valve or receiver/drier. Turn A/C switch off and air condi- tioner stop for 10 minutes start engine turn both A/C switch and fan switch on. Does malfunction occur after compressor turn on? Yes Go to next step No Replace condenser and vacuum refrigerant line more than 30 minutes by vacuum pump, and re- frigerant to specified level. (Since water has intermixed in receiver/drier and it is saturated, replacement is necessary.) 9 Verify that expansion vale heat- sensing tube within cooling unit is positioned securely and correctly is expansion valve heat-sensing tube within cooling unit securely in- stalled in proper position? Yes Replace expansion valve. (Since valve closes too much replacement is necessary.) No Install heat-sensing tube securely in proper posi- tion. 10 Inspect refrigerant lines inspect refrigerant lines  Is piping free of damage and cracks?  Are piping connections free of oil grime? (visual inspection)  Are piping installation points on a/c compressor free of gas leakage?  Are piping installation on cooling unit free of gas leakage?  Perform gas leak inspection us- ing gas leak tester. Are above items okay? Yes Go to next step No If piping or an A/C component is damaged or cracked, replace it.