TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 600 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Trouble Shooting:- Step Checks IF YES IF NO 1. Are Relay Contacts weld / Stuck Open? Replace the Relay Go to Step 2 2. Is there wiring harness electrical continuity between ECU pin 141& Fan relay pin X. Also Check continuity between the Main Relay supply and the Fan relay Coil pin X and Battery Supply to Relay contact pin X. Go to Step 3 Establish continuity by rectifying harness connections as per the Circuit schematic 3. Are there any pins damaged at EMS ecu Connector Replace the connector or wiring harness Go to step 4 4 Are there any pins backed out from the EMS ecu Connector Rectify/Replace Connectors Go to Step 5 5 Is relay getting Supply at its pin XX Go to Step 6 Repair the harness as per the schematic 6 Is Fan Relay control Pin 141, Open Circuited? Repair the harness as per the schematic Go to Step 7 7 Is fan Properly Working or stalled Rectify / Replace Fan Go to Step 8 8 Fault Still Persists? Replace relay and then if Fault still persists then Replace EMS ecu Follow the steps again for reconfirmation DTC’s confirmation:- After rectification, ensure the following points by referring engine parameters using TML diagnostic tool before handing over to customer. Perform the I/O test for radiator fan using the diagnostic tool. If the test result is successful then only the fault rectification is confirmed.