TIAGO TIGOR BSVI - SERVICE MANUAL - DTC 24-12-2021

TATA BSVI Gasoline Program – EMS ECU Bosch DTC Troubleshooting Service Manual Version: 1.2 Date: 18-12-2019 Prepared By: Sunita Mandlik Checked By: Yeshwant Jadhav Approved By: Satish Kumar Document Part No: 2921 02 xxx xxxx Page: 1196 of 1498 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Flow Chart: - Sensor supply line Short circuit to Battery Sensor Signal line Short circuit to Battery/ Sensor Supply/ Ground It is ok? It is ok? Repair the harness as per the schematic START Is there wiring harness electrical continuity between ECU pins 130 & Auto start stop LED lamp indicator continuity between ECU pin 130 & Auto Start Stop LED Lamp indicatorcontinuity between ECU pin 130 & Auto Start Stop LED Lamp indicator Establish continuity by rectifying harness connections as per the circuit diagram It is ok? Replace the connector or wiring harness Is there any pin backout from the connector Rectify /replace connector Fault still persists then Replace the switch Fault still persists then Replace the EMS ECU END Rectify wiring harness Is ESS lamp indicator pin 130 open circuited Is there any pin damage at EMS ECU connector Repair the harness as per the schematic Repair the harness as per the schematic It is ok? It is ok? It is ok? It is ok?